English
A variety of grooves, slots, and pockets in the work-piece may be produced from a variety of tool bits. Common tool bit types are: square end cutters, ball end cutters, t-slot cutters, and shell mills. Square end cutters can mill square slots, pockets, and edges. Ball end cutters mill radiused slots or fillets. T-slot cutters mill exactly that: T-shaped slots. Shell end cutters are used for large flat surfaces and for angle cuts. There are variations of these tool types as well.
There are four critical angles of each cutting tool: end cutting edge angle, axial relief angle, radial relief angle, and radial rake angle.
Depending on the material being milled, and what task should be performed, different tool types and geometry may be used. For instance, when milling a material like aluminum, it may be advantageous to use a tool with very deep, polished flutes, a very sharp cutting edge and high rake angles. When machining a tough material such as stainless steel, however, shallow flutes and a squared-off cutting edge will optimize material removal and tool life.
A wide variety of materials are used to produce the cutting tools. Carbide inserts are the most common because they are good for high production milling. High speed steel is commonly used when a special tool shape is needed, not usually used for high production processes. Ceramics inserts are typically used in high speed machining with high production. Diamond inserts are typically used on products that require tight tolerances, typically consisting of high surface qualities (nonferrous or non-metallic materials).
In the early 90s, use of coatings became more common. Coatings can provide various benefits including wear resistance, reduction of friction to assist with chip evacuation, and increased heat resistance. Most of these coatings are referred to by their chemical composition.
Aluminum titanium nitride (AlTiN) coated end mills, coated using the cathodic arc deposition technique
| Coating | Appearance | Remarks |
|---|---|---|
| TiN | Yellow/Gold | A basic coating that has fallen out of wide use on end mills. Still sees wide use in drills. |
| TiCN | Bluish-grey | |
| TiAlN and AlTiN | Dark grey or dark purple | An extremely popular coating. |
| TiAlCrN, AlTiCrN and AlCrTiN | Bluish-grey | A PVD coating |
Though PCD veins is not a coating, some end mills are manufactured with a 'vein' of polycrystalline diamond. The vein is formed in a high temperature-high pressure environment. The vein is formed in a blank and then the material is ground out along the vein to form the cutting edge. Although the tools can be very costly, they can last many times longer than other tooling.
Advances in end mill coatings are being made, however, with coatings such as Amorphous Diamond and nanocomposite PVD coatings beginning to be seen at high-end shops (as of 2004).
Although coatings have a typical color, manufacturers may modify the coating process or add additives to change the appearance without affecting the performance as part of their branding. Bright blues, reds and turquoise are among the "unnatural" colors.
End mills are typically made on CNC (computer numeric controlled) tool and cutter grinder machines under high-pressure lubricants such as water, water-soluble oil, and high-flashpoint oil. Grinding inside the machine is accomplished with abrasive wheels mounted on a spindle (and in some cases, multiple spindles). Depending on what material is being ground, these wheels are made with industrial diamond (when grinding tungsten carbide), cubic boron nitride (when grinding cobalt steel), and other materials (when grinding, for instance, ceramics), set in a bond (sometimes copper).
